Top Kit Vs Bottom Kit
You’ll want a Top Kit if:
There is less than 1.5 inches of clearance between the tank and the throttle housing at full right turn.
There’s a heated grip wire that comes out of the bottom half of your rubber grip flange.
You’ll want a Bottom Kit if:
There’s a heated grip wire that comes out the top half of your rubber grip flange.
There are no other interferences. The majority of motorcycles will be able to use the Bottom Kit.
Can Am Ryker Cruise Control Kit Oem New 219401135
- Make sure this fitsby entering your model number.
- Electronic Cruise Control
- Ergonomic speed regulator integrated on the handlebars
- Easy access, easy installation
- This item: Can Am Ryker Cruise Control Kit Oem New 219401135$156.77Only 3 left in stock – order soon.Sold by Central Texas Powersports and ships from Amazon Fulfillment.Get it as soon as Sunday, Sep 18
- Sold by KiWAV and ships from Amazon Fulfillment.Get it as soon as Sunday, Sep 18
- Sold by zuparts and ships from Amazon Fulfillment.Get it as soon as Sunday, Sep 18
Fitting Hand Guards 2022 Ryker Sport
Hello everyone, I have a 2022 Ryker Sport. I purchased the BRP hand guards but when I went to install them I observed that the cruise control covers one of the holes in the handle bars that the hand guard goes into. Have any of you run across this issue? I know on the Rally the cruise control is attached to the hand-guard. Any advice or suggestions would be helpful. Have already contacted BRP and multiple dealers but nobody seems to know anything. Thanks ahead of time.
Last edited by Peter Aawen 06-18-2022 at 01:33 AM.Reason: Caps & title -)
Also Check: What Is The Best Cruise For The Money
Is There A Cruise Control Available For Older Model Rykers
I know that there is Cruise control available on the 2022 models and it seems like it wont be available from Can Am for older models because it will require ECU re-mapping. But has anyone heard if this will be possible in the aftermarket? Because buying the cruise control from canam and paying for a ecu flash/remap is a lot cheaper than selling my ryker and buying a new one.
My internet searches have not found one available the last time I checked . You can research a cheap alternative if you are driving long distances, it is called a throttle lock. There are various types of throttle locks/throttle assistants, so do your own due diligence. They are considered dangerous by some people, while other people use them daily. I’ve operated old school buses before that all had them equipped from the factory, and some older cars and pickups. I have never used a throttle lock on a bike so I would be the worst person to ask an opinion of.Good luck. I know if I was driving long distances I wouldn’t be holding that throttle open for hours straight. My drives aren’t normally on the highway, maybe a 30-50 minute stretch tops. It has been snowing for the last two months so the only thing I am driving is my computer chair and pickup.
Last edited by SportsterDoc 01-29-2022 at 04:57 PM.
S To Determine Fitment
First, is there enough room for the ATLAS? All you need is a gap of 0.1″ or greater between the grip and the throttle housing. That’s roughly 3 bank cards thick.
You’ll want the Bottom Kit
If theres a heated grip wire that comes out the top half of the rubber grip flange.
If you have more than 1.5 inches of clearance between the inner plastic throttle tube and the gas tank at a full right turn.
If there’s a bulge, bracket or object sticking out of the top half of the throttle housing that would interfere with the body of the ATLAS.
You’ll want the Top Kit
If theres a heated grip wire that comes out the bottom half of the rubber grip flange.
If you have less than 1.5 inches of clearance between the inner plastic throttle tube and the gas tank at a full right turn.
If there’s a bulge, bracket or object sticking out of the bottom half of the throttle housing that would interfere with the body of the ATLAS.
You May Like: Which Cruise Lines Depart From New York